Enable and Run Data Targets

Before you can enable and run a data target through the quality control check process, layer and field mapping must be completed and the Data Target Card status must be Ready to Run. See Layer and Field Mapping to configure a data target's layer and field mapping.

Note: You cannot run a data target when a partial dataset was uploaded inventory changes. If this happens, the run button is disabled, and an alert is shown on the Data Targets page informing you that a complete dataset must be uploaded before you can run your data.

Once mapping is finished, complete the following to run the data target.

  1. In the Navigation Bar, click Data Targets.
  2. Locate the Data Target Card(s) for the data target(s) you want to run.

  3. Verify the status is Ready to Run.

    If the status has an alert, correct before continuing.

  4. Click the Enable check box in the Data Target Card (e.g., Enable GeoComm ECRF Emergency Call Routing Function. Receives location information (either civic address or geo-coordinates) as input and uses this information to provide a URI that can be used to route an emergency call toward the appropriate PSAP for the caller’s location. Depending on the identity and credentials of the entity requesting the routing information, the response might identify the PSAP, or an Emergency Services Routing Proxy (ESRP) that acts on behalf of the PSAP to provide final routing to the PSAP itself. The same database that is used to route a call to the correct PSAP might also be used to subsequently route the call to the correct responder, e.g., to support selective transfer capabilities. Data Target v13).

    The outline of the Data Target Card changes to blue and the Enable counter at the bottom of the page shows the number of data targets selected.

  5. Click Run Data.

    A confirmation message is shown.

  6. Click Yes, Run Data.

  7. Click OK.

    Note: The Enable check box remains selected for subsequent data runs. When a card is enabled and all mapping is complete, jobs run automatically after a successful upload when your schema matches.